ELRO HA68S Multi-zone professional alarm system USERS MANUAL - Manual (Page 23)

DIGITAL DIALER SETUP
Scroll through the menu until ‘4-2 Digital Dial Setup’ is displayed and press
Note: After completing the Digital Dialer Setup press to return to the top
level programming menu.
PHONE NUMBER
Scroll through the menu until ‘:1 Phone No:’ is displayed. The current setting
will also be display.
To change the setting press .
Enter the phone number (32 digits max. ranging from 0~9, *, #, ).
Press to save and exit, or
Press to exit without saving.
Notes:
Press to insert a 3.6s pause in the dialing sequence.
Press to move the cursor left.
Press to move the cursor right.
Press to delete the character under the cursor.
Press and hold to erase the entire phone number.
UNIT ID NUMBER
This helps central monitoring station set an ID number for the user whose
system is connected to their center.
Scroll through the menu until ‘:2 Unit ID No:’ is displayed. The current setting
will also be displayed.
To change the setting press .
Enter the ID number (4 digits max. ranging from 0-9, B, C, D, E, F)
Press to save and exit, or
Press to exit without saving.
-21- -44-
INITIAL TESTING
As the system is initially installed it is recommended that each device is tested in
turn as it is installed, (refer to testing instructions for particular device).
TESTING AN INSTALLED SYSTEM
The Control Panel has a programmed test routine. You may test the system at
any time, however it is recommended that the system is tested at regular
intervals not exceeding 3 months.
With the system in Disarm Mode
Press This puts the system into Test Mode.
User Password
Use the and buttons to scroll through the menu and press to select
the displayed test function or sub-menu.
Note: After completing all required test functions, press to leave Test mode
and return to Disarm mode.
WALK TEST
Before commencing testing, please ensure that there is no movement in any PIR
protected area, all doors/windows protected by Magnetic Contact Detectors are
closed and that all battery covers and housings are correctly fitted.
Scroll through the top level Test Mode menu until ‘WALK TEST’ is displayed and
press . ‘Walk Test Waiting…’ will be displayed.
1. Trigger each detector on the system by either walking into a PIR protected
area or by opening a door/window protected by a Magnetic Contact detector.
As each detector is triggered the Control Panel will chime to indicate that an
alarm signal has been received and the identity of the zone that the detector
is configured for will be displayed.
2. Operate detector anti-tamper switches by opening the case of the device. As
the switches are operated the Control Panel will chime and zone name will be
displayed.
3. Activate each button on the Remote Control in turn. As each button is pressed
the Control Panel will chime and the button name will be displayed. (e.g.
‘REMOTE CONTROL DISARM’).
Press to exit Walk Test and return to the top level Test Mode menu
TESTING THE SYSTEM
EN EN