ELRO HA68S Multi-zone professional alarm system USERS MANUAL - Manual (Page 4)

-63- -2-
INTRODUCTION AND OVERVIEW
MULTIPLE USERS
The system allows for up to 5 Users and a Master User to be configured. This
allows the system Event Log to maintain a record of which users have armed
and disarmed the system. Each user will have a different Password. In addition a
4 second voice recorder facility enables the users name to be recorded for use
with the Latch-Key facility.
Only the Master User has access to the programming functions and is able to
configure the system.
Note: Each Remote Control Units on the system will be recorded.
SYSTEM ARMING
The system has a full ‘Arm’ and two ‘Partial Arm’ modes. ARM will ‘Arm’ all zones
while the ‘Partial Arm’ modes will only arm the zones that are enabled for the
particular partial arm mode.
For example:
The system could be configured such that during night time, ‘Partial Arm 1’
would arm only zones protecting the lower floor and outbuildings leaving the
upper floor free for movement without triggering the alarm.
During the day while the property is occupied ‘Partial Arm 2’ would arm only the
zones protecting the outbuildings. However, when the property is left un-
occupied, the full ‘Arm’ mode will arm all zones to protect the entire property,
(i.e. upper and lower floors and outbuildings).
ZONES
The system incorporates 32 wireless Alarm Zones for the connection of the
system detectors that are used to independently monitor different areas of the
property. In addition to standard intruder protection, each zone may also be
configured to operate in one of four other modes:
- ‘Medical Help’ mode provides 24 hour monitoring of any panic switches
incorporated into the system.
- ‘24-hour Intruder’ mode provides 24 hour intruder protection for areas/zones
where continuous monitoring is required, (e.g. gun lockers).
- ‘Fire’ mode provides 24 hour monitoring of any Fire/Smoke detectors
incorporated into the system.
- ‘Intruder’ mode allows a zone to be monitored while the system is armed. If a
detector on a test zone is triggered an entry will be recorded in the Event Log
and an alarm will occur.
‘Panic’ mode provides 24 hour monitoring of any emergency being occurred.
Activation of any panic switch will immediately initiate a Full Alarm condition.
EN EN