ELRO HA68S Multi-zone professional alarm system USERS MANUAL - Manual (Page 29)

REPLAY USER MESSAGE
Scroll through the menu until ‘:5 Replay User Message’ is displayed.
Press to replay the user message. Press to exit.
CODE LEARNING FROM REMOTE CONTROL
Each user has his own remote control. This enables the control panel to learn
the specific code from each remote control.
Scroll through menu until ‘:6 Remoter’ is displayed and press .
CODE LEARNING
Pressing button on the remote control will enable the control panel to learn
the ID code.
Scroll through the menu until ‘6-1 Learning ID’ is displayed.
Three possibilities would happen as follows:
Learning OK – the ID code was learned by the Control Panel successfully.
Time Out – the time involved for learning the ID code is 60s. During this
duration, fail to press the button on the remote control would result in
overdue programming.
ID Duplicate – the same ID code was learned by the Control Panel beforehand.
Use another remote control for code learning.
ALARM ALERT
This allows the user to decide whether the built-in siren in the control panel will
be activated when pressing the panic switch on the remote control.
Default setting: ON
Scroll through the menu until ‘6-2 Siren’ is displayed.
To change the setting press .
Press to enable the Siren, or Press to disable the Siren.
Note: If enabled, the operation of siren will depend on the respective setting on
‘System Setup’. If disabled, all of the sirens won’t be activated despite the
‘System Setup’ being enabled.
DELETE REMOTE CONTROL
In case of unexpected factors, this facility allows you to delete the remote
control setting from the Control Panel.
Scroll through the menu until ‘6-3 Del data’ is displayed.
To change the setting press .
Press to delete the remote control setting, or
Press to keep the same setting.
Press to return to the top level User-Setup menu.
-27- -38-
Press to save and exit, or Press to exit without saving.
PARTIAL ARM 1
This controls whether the zone is active when Partial Arm 1 is armed.
Default setting: OFF
Scroll through the menu until ‘6: Partial Arm 1’ is displayed. The current
setting will also be displayed.
To change the setting press .
Press to enable the Zone in Partial Arm 1, or
Press to disable the Zone in Partial Arm 1.
PARTIAL ARM 2
This controls whether the zone is active when Partial Arm 2 is armed.
Default setting: OFF
Scroll through the menu until ‘:7 Partial Arm 2’ is displayed. The current
setting will also be displayed.
To change the setting press .
Press to enable the Zone in Partial Arm 2, or
Press to disable the Zone in Partial Arm 2.
MAGNETIC CONTACT DETECTOR
This allows the control panel to be notified as to whether the magnetic contact
detector is active or inactive when the system is disarmed.
Default setting: ON
Scroll through the menu until ‘:8 Magnetic O/C Detector’ is displayed. The
current setting will also be displayed.
To change the setting press .
Press to enable the Magnetic Contact Detector, or
Press to disable the Magnetic Contact Detector.
AUTO REPORT
This feature, if enabled, allows the detector to be feed back the latest status to
the Control Panel periodically.
Default setting: ON
Scroll through the menu until ‘:9 Auto Report’ is displayed. The current setting
will also be displayed.
EN EN