GxT V016-01, Ferret 16 GasLink II 5-Gas Analyzer - Manual (Page 5)

5
Connecting to the Vehicle
Battery Power Leads
Connect the RED lead to the Battery
Positive, and the BLACK lead to
Battery Negative post. The analyzer
is protected in case you connect the
leads improperly.
Exhaust Sample Hose
Insert the sample hose into the
tailpipe. Be sure to route the sample
hose away from the exhaust flow.
The water separator should not be
vertical or horizontal, and should
not be directly in the exhaust flow.
When used during a road test, use
a hose clamp to secure the probe in
the tailpipe.
Spark Pickup
Clamp the RED spark pickup around
any sparkplug wire with the “Spark
Plug” label facing towards the
sparkplug. On systems where no
spark plug wires are available, the
pickup may be placed around the wire
feeding the coil primary.