Hydrotech PURA ADDON SERIES User Manual
Page 21
16
ADDON SERIES - SYSTEM ASSEMBLY AND ACTIVATION PROCEDURES Cont’d
INSTALL TUBING cont’d
QUICK CONNECT FITTINGS
Fittings consist of two parts: a Body and a collet.
1. To install a tube, push it through Collet until it seats firmly at the
bottom of fitting (Figure 8.A. and 8.B.)
2. To remove a tube, push and hold Collet against Body while pulling
tube out (Figure 8.C.).
ACTIVATE SYSTEM
CAUTION: Verify that inlet and outlet ports are connected to
appropriate inlet/outlet pipes (see Figure 8).
WARNING: NEVER LOOK DIRECTLY AT A LIGHTED UV LAMP.
ALWAYS LOOK AT LAMP THROUGH FINISH CAP
ONLY.
1. Plug system into an electrical outlet. The finish cap should
illuminate within one minute, indicating UV lamp is on. If it does
not, unplug system, verify the UV lamp is securely plugged into
four-pin socket, and repeat this Step.
NOTE:
UV lamp should remain on at all times during use
because; repeated starting of UV lamp shortens lamp
life, and UV lamp requires a warm up period of 1-2
minutes.
2. Turn on water supply and check for leaks. If there are leakages
in the quick connect fittings, check for the “O” ring placement and
make sure that the tube is inserted properly (refer to Figure 8).
3. Flush system, connectors, and water lines for several minutes to
remove carbon fines.
NOTE:
When an ultraviolet water treatment system is unused
for several hours, water within system could become
warm. This is a normal condition. To cool the water,
dispense water from system.
NOTE:
System is now ready for use.
Figure 8 How to Use Quick-Connect Fittings
Service Requirements
Recommended Service Intervals
To ensure the system operates at its optimum level,
certain routine maintenance must be performed.
Frequency of maintenance performance will depend on
source water quality and level of system usage.
CLEAN: Every 3 to 6 months
DISINFECT: At least once a year.
UV lamp #10 or #20: Change Annually
Quartz Sleeve #11 or #20: Clean when changing lamp. Replace
only if damaged or cannot be cleaned by non-abrasive methods.