CAME Frog-AEP24 Kit - Manual (Page 11)

2.3 - Wiring in the Safety Photocells
SAFETY BEAMS SHOULD BE FITTED APPROXIMATELY
15 INCHES FROM GROUND LEVEL
2.4 - Inserting the Radio Frequency Card
SAFETY BEAMS SHOULD BE FITTED APPROXIMATELY
15 INCHES FROM GROUND LEVEL
CONTROL PANEL
10 11 2 C1
C
NC
RX
10
11
TX
10
11
ZA4
SAFETY
BEAM
TRANSMITTER
SAFETY
BEAM
RECEIVER
IF FITTING A SECOND ARC LINE SET OF SAFETY BEAMS THEN C & NC MUST
BE WIRED IN “SERIES”
INSERT THE RADIO FREQUENCY CARD INTO
THE SMALL SOCKET ON THE CONTROL
PANEL (ENSURE THAT THE POWER IS
TURNED OFF TO THE CONTROL PANEL
BEFOREINSERTING THE FREQUENCY CARD)
ANTENNA WIRING
POINT
10