Clear-Com Eclipse-Omega - Manual (Page 50)

Clear-Com Communication Systems
Eclipse Matrix Installation Instruction Manual
4 - 2 0
FOR-22 4-WIRE/RADIO INTERFACE WIRING
The FOR-22 4-wire/radio interface connects two external 4-wire
circuits to the matrix. Camera intercoms, two-way radios, microwave
and satellite links, IFBs, and program audio in and out are candidates
for use with the FOR-22.
A FOR-22 interface connects to an Eclipse matrix through the two
RJ-45 connectors on the IMF-3 or IMF-102 rear panel assembly to
which the FOR-22 is connected. One RJ-45 connector is for the first
channel of the interface. The second RJ-45 connector is for the second
channel.
The user side of the FOR-22 for each channel appears on a DB-9M
connector on the rear of the IMF-3 for IMF-102 frame. Figure 4-14
shows the pinout of either one of these connectors. Each channel is
identical.
Figure 4-14: Pinout of the DB-9M I/O Connectors for FOR-22s
The following sections describe how to wire for the various type of
inputs and outputs available on this connector:
• External audio devices
• Call signal input
• Relay contacts.
Note: Shielded cable should be used.
External Audio Devices
Connect external audio devices to the FOR-22 ports through the two
DB-9M connectors labeled “I/O” on the rear panel. Both audio input
and output are transformer isolated. For more information on the
Audio Input
Logic Input (+/- 4 to 50 V)
Relay Normally Open
Audio Output
Audio Output
Audio Input
Relay Normally Closed
Relay Wiper
Logic Input (+/- 4 to 50 V)
1
2
9
8
7
6
5
4
3