Clear-Com Eclipse-Omega - Manual (Page 70)

Clear-Com Communication Systems
Eclipse Matrix Installation Instruction Manual
5 - 2
Figure 5-2: Example of Fiber-Optic Connected Matrices
The serial port to serial port wiring is not a typical RJ-45 to RJ-45
jumper cable. It is possible to construct such a cable or use a
punch-down block for the crossover wiring. The Seimon cable tester
will not test this wiring. Figure 5-3 illustrates dedicated trunk wiring.
The matrix is connected to an Ethernet network with the RJ-45 sockets
labeled “LAN 1” and “LAN 2” on the rear of the Eclipse Omega or
Median matrix, or the RJ-45 socket labeled “LAN” on the rear of the
Eclipse Pico or Eclipse-32 matrix. The connectors have standard
Ethernet pin assignments, shown in Figure 5-4.