Hach-Lange SI794 D tr User Manual - Manual (Page 33)

Note: Characters represented in gray are blinking and can be edited.
Code Display Action Choices
o1. Select configuration
(Press conf key).
Enter passcode “1200”
(Select position using arrow
key and edit number using key.
When the display reads “1200”,
press enter to confirm.)
The transmitter is in the HOLD
mode (HOLD icon is active).
Select sensor Type A / B
(see table on left-hand side)
Select using arrow key.
Press enter to proceed.
Type A,
Type B
Select measurement procedure
(valid for all following settings):
• SAt: Saturation (%)
• Conc: Concentration (mg/L
or ppm)
Select using arrow key.
Press enter to proceed.
%
mg/L
ppm
After correct input a
welcome text (CONF) is
displayed for approx. 3 sec
33