Hach-Lange SC 1000 Controller Enhanced Communications - Manual (Page 42)

42
Error messages
4.4 Notification by e-mail in the event of error messages/warnings
If an error occurs, an e-mail containing a description of the error can be sent to one or
more recipients. Up to four configuration sets can be created for e-mail notification.
Each configuration set includes the following (not exhaustive):
• The e-mail address of the recipient.
• Selected errors, warnings and events associated with connected probes that trigger
e-mail notification.
In order to use e-mail notification, an active connection is required between the sc1000
controller and computer (GPRS or Ethernet-based) . An e-mail account must also be set
up with an e-mail provider. This provider must support the sending of e-mails via an
SMTP server (outgoing mail server).
4.4.1 sc1000 controller software settings
E-mail notification is configured from the following sc1000 controller menus:
SYSTEM SETUP
E-MAIL
E-MAIL 1-4
E-MAIL ADDRESS
Specifies the e-mail address to which notifications are sent. Several e-mail addresses can be
specified. These must be separated by a space.
LANGUAGE Selects the E-MAIL language
E-MAIL LIMIT
(0–100)
Specifies the maximum number of e-mail notifications that the sc1000 controller can send
within a 24-hour period. The 24-hour cycle begins from the START TIME entered.
REPEAT
(0–24h)
Specifies the interval at which unconfirmed error messages are sent again to the E-MAIL
ADDRESS.
START TIME
Specifies the start time for the REPEAT function.
E.g.: REPEAT=6 h, START TIME=02:00: Unconfirmed messages are sent again at 02:00,
08:00, 14:00, 20:00.
INHIBIT
Default: OFF
ON: If the same error occurs more than once, e-mail notification is only sent for the first
instance.
CONFIGURE Specifies which devices are monitored and which error messages/warnings are sent by e-mail.
ADD
Adds devices to the configuration list. All connected devices are displayed, including the
sc1000 controller. Devices already added are grayed out and cannot be selected.
REMOVE Removes devices from the configuration list. All configured devices are displayed.
DEVICE NAME
1-n
Compiles individual messages for a device.
The ERRORS and WARNINGS menus contain all errors/warnings for the selected device.
1=An e-mail is sent in the event of an error/warning
0=An e-mail is not sent in the event of an error/warning
SELECT ALL: Activates (1) or deactivates (2) all menu options at once.
SENDER E-mail address of the sc1000 controller. Used to specify sender.
SMTP SERVER Outgoing mail server of e-mail provider. The server name is supplied by the e-mail provider.
USER NAME
User name for logging on to the SMTP server of the e-mail provider. The user name is
supplied by the e-mail provider.
PASSWORD SMTP server of the e-mail provider. The password is supplied by the e-mail provider.