Hach-Lange SC 1000 Controller Enhanced Communications - Manual (Page 9)

9
Section 3 Installation
3.1 User requirements
Only appropriately trained specialist personnel are authorized to install and operate the
computer system and sc1000 controller. Users must possess sound knowledge of
network technology and computer systems.
3.2 General requirements associated with remote maintenance
Every specified requirement must be fulfilled, otherwise remote maintenance and/or
browser-based access to the sc1000 controller will not be possible, and damage to the
system may occur.
3.2.1 Requirements associated with the sc1000 controller
All safety information and instructions provided in the sc1000 controller manual must be
observed.
Additional requirements:
Browser password allocation
A browser password must be assigned before the Ethernet/GPRS connection is set up to
make sure browser-based access to the sc1000 controller is possible.
1. Select SYSTEM SETUP>BROWSER ACCESS>PASSWORD from the main menu of
the sc1000 controller.
2. Assign a browser password.
Assessment of GPRS availability at location
GPRS must be available at the sc1000 controller's location for this to be accessible
via GPRS.
Note: The availability of GPRS must be ensured at the controller's location.
Installation of Modbus TCP software module
If Modbus TCP support is used, the Modbus TCP software module must be licensed and
an activation key provided.
3. To activate either a trial- or permant license enter SYSTEM SETUP>LICENSE
MANAGEMENT.
3.2.2 Requirements associated with the computer
The computer to be connected to the sc1000 controller must be capable of establishing a
workable Internet connection.
The following requirements must be fulfilled:
• The user account used to log in to the computer must be assigned administration
rights
• A web browser must be installed
• An Internet connection must be available
SYSTEM SETUP
BROWSER ACCESS
PASSWORD