3 install the open loop control unit – Hach-Lange SIGMATAX2 User Manual
Page 18
Advertising
18
Installation
3.1.3
Install the open loop control unit
N O T I C E
Install the open loop control unit in a dry location out of direct sunlight.
N O T I C E
The Teflon sample lines must be laid without sharp bends. Shortening or extending the lines will
lead to problems when the samples are transported.
Each process instrument must have a separate drain tube!
The individual device drains may only be combined in a larger drain pipe with regular water
throughput.
Make sure that an area of 5 cm is kept free around the entire instrument to enable air to
circulate (distance from the wall of the building, cable channel etc.).
Advertising