Printing data – Hach-Lange TITRALAB 840_845 User Guide User Manual
Page 69
Printing data
69
6. Printing data
6. Printing data
6. Printing data
6. Printing data
6. Printing data
✶ IMPORTANT ✶
Before printing, it is necessary to perform the following:
1.
Enter the Setup window: press Stop 3 seconds in the Main
window.
2.
Select the Printer
Press 1.
In Configuration, select Printer = 80 columns and
Format = Listing or Page by Page.
3.
Enter User ID (if required)
In Configuration, select User ID = Yes. You will be
prompted to enter a user ID at the start of a run method. This ID will
appear on the printouts.
4.
Customise the printout (if required)
In Configuration, press 3.
In Customise, enter the name of your workstation (max. 4 lines
of 32 characters). This information will appear as a header at the
start of the printout.
5.
For automatic printout - select a condensed or detailed printout
In the Printouts screen of the Edit method/reagent/electrode,
select Detailed = High to obtain a full detailed printout.
Select Low for condensed printout.