INTELLINET NETWORK 524681 User Manual - Manual (Page 107)

100
3-3-1 Access Control
This function allows or denies computers with specific MAC
addresses access to the network; it can also allow or deny
computers with a specific IP address, protocol or port.
Click “Firewall” on the left side of the Web management interface,
then click “Access Control.” The following message will be
displayed on your Web browser:
Below are descriptions of the options:
Enable MAC
Check this box to enable MAC address based
Filtering (1): filtering, and select “Deny” or “Allow” to
determine the behavior of the MAC filtering
table. If you select “Deny,” all MAC addresses
listed in filtering table will be denied from
connecting to the network; if you select “Allow,”
only MAC addresses listed in the filtering table
will be able to connect to the network, and all
other network devices will be rejected.
Client PC
Enter the MAC address of the computer or
MAC address (2): network device here. Dashes ( - ) and colons ( : )
are not required; i.e., if the MAC address label
of your wireless device is “aa-bb-cc-dd-ee-ff” or
1
2 3
5 6
7
8 9 10
12
13 14 15
16
11
0
4