INTELLINET NETWORK 524681 User Manual - Manual (Page 74)

67
SSID (2):
This is the name of the wireless router. You can
type any alphanumerical characters here
(maximum of 32 characters). ESSID is used to
identify your own wireless router from others
when there are other wireless routers in the
same area. The default SSID is “INTELLINET”;
2.4 GHz (B) 2.4GHz band only allows 802.11b wireless
network clients to connect to this router
(maximum transfer rate 11 Mbps).
2.4 GHz (N)
2.4GHz band only allows 802.11n wireless
network clients to connect to this router
(maximum transfer rate 150 Mbps).
2.4 GHz (B+G)
2.4GHz band only allows 802.11b and
802.11g wireless network clienst to connect
to this router (maximum transfer rate 11
Mbps for 802.11b clients; 54 Mbps for
802.11g clients).
2.4 GHz (G)
2.4GHz band only allows 802.11g wireless
network clienst to connect to this router
(maximum transfer rate 54 Mbps).
2.4 GHz (B+G+N) 2.4GHz band allows 802.11b, 802.11g and
802.11n wireless network clients to connect
to this router (maximum transfer rate 11
Mbps for 802.11b clients; 54 Mbps for
802.11g clients; 150 Mbps for 802.11n
clients).
NOTE: For 802.11b and 802.11g mode, the signals can be transmitted
only by antenna 1 (the antenna on the right side of the rear panel).
For 802.11n mode: The router is operating in a 2T2R Spatial
Multiplexing MIMO configuration. 2 antennas are for signal
transmitting and 2 antennas are for signal receiving.