INTELLINET NETWORK 524681 User Manual - Manual (Page 98)

91
Reset (12):
Unselect all mappings.
After you finish the settings, click “Apply” (13) and the following
message will be displayed on your Web browser:
Click “Continue” to go back and continue with the router setup
procedure, or click “Apply” to reboot the router so the settings will
take effect. (Wait for about 30 seconds while the router reboots.)
If you want to reset all settings on this page back to previously
saved values, click “Cancel.”
3-2-3 Virtual Server
This function allows you to redirect a port on the Internet IP address
(on a WAN port) to a specified port of an IP address on the local
network so you can set up an Internet service on the computer on
the local network without exposing it on the Internet directly. You
can also build many sets of port redirection to provide many
different Internet services on different local computers via a single
Internet IP address.
Click “NAT” on the left side of the Web management interface, then
click “Virtual Server.” The following message will be displayed on
your Web browser: