KT&C KVR-0412H - Manual (Page 68)

68
 In Pan/Tilt mode, the icon is displayed on the bottom of the screen.
 Following is the key usage found in Pan/Tilt mode.
Key Function
Up/Down/Left/Right rotation
Zoom out
Zoom in
Focus near
Focus far
Iris Close
Iris Open
Save Preset
Go to the Preset
Go to OSD main menu
Run Group Tour 1~9
Run Pattern 1~9

To use a mouse in Pan/Tilt mode, please move the cursor to the lower portion near the center of the screen. To use front
button in Pan/Tilt mode, please push setup button.
 To activate PTZ control OSD menu, user must move the cursor to the bottom right portion of the screen. A key pad control
will show as follows:
 To save current camera number, select Preset No and button click.
 To move to preset, select preset No and button click.
 Available 1 ~ 255 Preset numbers can saved it depends on camera specification.
 As explained earlier in 4.4.2., press Menu button to pop-up PTZ camera OSD setup screen and set up Tour and Pattern
items.
-
Since these functions make use of a memory function of the camera itself, user should set them in Camera OSD.
- Once user completes the setup, close the Camera OSD menu.
- User can conveniently use Tour and Pattern functions simply by clicking Tour and Pattern buttons.
- Particulars on how to setup each function on OSD Menu are found in the manual of a corresponding camera.
NOTE
Suppose a command for using Tour function is 71 ~ 79 + Preset and if you had set Tour to 70, use Preset No: 1 ~ 9 + Tour
button to benefit the Tour function (70 + 1~9).