Coast PX25 - Manual

PX25 instructions
Battery Installation
Turn the end cap in a counter-clockwise direction to remove the cap.
Remove the battery cartridge.
Place three AAA batteries into the cartridge in the direction indicated on the cartridge.
Replace the cartridge in the light with the red end going in first.
Replace the tail cap and turn it clockwise to tighten it until it is fully closed.
On/Off Operation
The PX25 has a rear switch on the tail cap.
To turn on the light, press the switch fully until it “clicks.”
To turn off the light, press the switch fully until it “clicks.”
The light can also be operated in “momentary” mode. Momentary mode is activated by partially depressing the
on/off switch (less pressure than required for a full click).