Controlled Products Systems Group 7200ETL-IL - Manual (Page 10)

10
Step 1. Press LED Enable once on the
right side of the circuit board. The STOP
LED should illuminate. This is a standard
condition.
Internal Limit Adjustment
Step 3. Activate the gate until the CLOSED LIMIT
LED is illuminated
Limit adjustment for left
movement
(gate moving to the left)


- less travel

- more travel
Limit adjustment for right.
Movement
(gate moving to the right)

- less travel


- more travel
Step 4. Adjust the corresponding limit switch for preferred
close position.
Step 5. Repeat steps 3 & 4 for setting the open limit
TIP: If the limits require extensive adjustment use a 13/32” or 25/64” socket with a portable drill
for course adjustment, then adjust manually for fine adjustment.
Step 2. Turn switch #1 OFF on the control board