Magnum Venus Plastech High Volume Pro Gun 60625-1 - Manual (Page 15)

High Volume Pro Gun Manual
Rev. 05/2012 Page | 15
Introduction:
Generally, the HV Pro Gun™ will not need to be completely disassembled for daily
cleaning. However, the entire gun should be disassembled and the o-rings and seals
replaced approximately every six months.
Disassembling the HV Pro Gun™ is easy; the gun breaks down into two separate
modules which are then disassembled further into their individual parts. A special tool
kit, which includes a specially designed HV Pro Gun™ tool and a packing assembly
tool, is available to aid in performing maintenance and repair.
This manual, the HIGH VOLUME PRO GUN REPAIR MANUAL, provides information
you need to perform simple maintenance and repair on your equipment.
Step-by-step assembly and disassembly procedures are included for each
component.
Please read the manual carefully. Follow the steps in the order given, otherwise you
may damage the equipment or injure yourself.
During Disassembly:
As you disassemble the equipment, lay out the components on a clean surface in the
correct order and direction. This will help you to reassemble them.
This manual covers the following High Volume Pro Gun Assemblies & Components:
58100-1-X
High Volume Pro Gun Assembly – Saturator
58104-1 High Volume Pro Gun Assembly – Manual Operated
58105-1 High Volume Pro Gun Assembly – For Chopper
58107-1 High Volume Pro Gun Assembly – With Chopper Assembly
60625-1 High Volume Pro Gun Assembly – Manual Putty
60625-1-INT High Volume Pro Gun Assembly – Manual Putty International
58103-1
High Volume Pro Gun Actuator Assembly
58106-1 High Volume Pro Gun Block Assembly
58106-1-INT High Volume Pro Gun Block Assembly - International
58110-1
Repair Kit – High Volume Pro Gun
58110-1-INT Repair Kit – High Volume Pro Gun – International