Magnum Venus Plastech High Volume Pro Gun 60625-1 - Manual (Page 25)

High Volume Pro Gun Manual
Rev. 05/2012 Page | 25
PACKING RING
RELIEF SPACER
CATALYST SEAL
PACKING RING
PACKING NUT
CENTER SPACER
SECONDARY SEAL
GUN BLOCK
RESIN SEAL
SECONDARY SEAL
RELIEF SPACER
VALVE ROD
PACKING NUT
Gun Block Assembly:
Install Secondary Seals
1. Place one of the secondary seals (58135-1) into the center of the gun block where
the center spacer goes. Gently push the secondary seal into position with something
flat, flush with the gun block. Use caution not to damage the seal.
2. Repeat the process for the other secondary seal.
Reinstall Center Spacer
1. Place the center spacer (58124-1) in the gun block, making sure that the center
spacer is aligned as accurately as possible with the slot facing up. Use caution
not to damage the secondary seals, already installed
Reassemble Catalyst Components
1. Place the catalyst components onto the seal installation tool in the following
order:
• Packing ring (58146-1)
• Catalyst seal (58127-1)
• Relief spacer (58123-1)
Note: The hole in the catalyst seal should be aligned with the port in the gun
block before inserting the seal installation tool into the gun block.