Magnum Venus Plastech High Volume Pro Gun 60625-1 User Manual

Page 27

Advertising
background image

High Volume Pro Gun Manual

Rev. 05/2012

Page | 27

Reassemble Resin Components

1.

Place the resin components onto the seal installation tool in the following order:

• Packing ring (58146-1)
• Resin seal (58126-1)
• Relief spacer (58123-1)

Note: Before inserting the packing tool, align the hole in the resin seal with the
hole in the gun block as closely as possible

PACKING RING

RELIEF SPACER

RESIN SEAL


2.

Insert the seal installation tool into the resin side of the gun block. Tap gently with
a rubber mallet or hammer, and then pull the packing tool out of the gun block.

3.

The resin components should be seated in the interior of the gun block against
the center spacer.

4.

Gently screw a packing nut (58122-1) into the resin side. Do not tighten.

Note: At this point, the resin side packing nut should only be hand tight.











Advertising
This manual is related to the following products: