Luminex IS Version 2.3 (IVD) - Manual (Page 73)

x MAP Technology Luminex 2.3 Software
PN 89-00002-00-254 Rev. B 63
• If you have entered lot information and have used the template
to set up a batch (even if it has not been acquired), you must
rename the lot.
Create a New Lot  To create a new lot:
1. On the Home tab, click New Lot. The Open Template dialog
box opens. See Figure 35.
Figure 35 Open Template Dialog Box
2. Highlight the template that will use the new lot information and
click Select. Then, continue with substep “a” or” b”.
a.) If this is a new template with no associated lot information, a
New Standard Lot or New Control Lot dialog box opens as
appropriate. Enter the standard and control numbers to
continue. Once you enter the numbers, the Update Lot
Information dialog box opens. See Figure 36 and Figure 37.
b.) If the template has associated lot information, the Update
Lot Information dialog box opens. To create a new lot when
there is an existing lot, click New Lot on the Standard or
Control section of the dialog box. A New Standard Lot or
New Control Lot dialog box opens. Enter the standard or
control lot number. See Figure 36 and Figure 37.
3. Click OK.
Figure 36 Add Lot Standard and Control Dialog Boxes
Note: Depending on the
types of products associated
with the template that you
select, the screen may vary
from the example in Figure 37.
That is, if you are creating only
standard lots, then only the
upper part of the screen
displays.