Maintenance procedures – Luminex IS Version 2.3 (IVD) User Manual

Page 93

Advertising
background image

x

MAP Technology

Luminex 2.3 Software

PN 89-00002-00-254 Rev. B

83

information for CAL 1, CAL2, CON1, and CON2 reagents are
correct.

5. Click OK to verify that the lot information is accurate.

Maintenance Procedures

Table 8 shows a recommended schedule for maintenance operations.

Table 8. Maintenance Operations:

Recommended Use Schedule

Operation

Recommended Use Schedule

Warmup

•

Daily

•

After four hours of system inactivity

Prime

•

Daily

•

To remove air from sheath fluid tubing

•

After performing these actions:
– refilling the sheath container
– removing and replacing sheath container
– changing the sheath fluid filter
– changing the syringe seal

Backflush

•

Troubleshooting and preventative
maintenance purposes only:
– to remove obstructions from the cuvette
– if fluid does not flow through the waste

tubing during prime cycles or during
sample acquisition

– if fluid drips from the sample probe during

priming and forms puddles of fluid on the
plate

Alcohol Flush

•

Daily

•

Before system calibration

•

After changing the sample probe

•

To remove air bubbles from the cuvette using
70% isopropanol or 70% ethanol

Sanitize

•

To decontaminate sample lines and cuvette
after biohazard contact using 10% to 20%
household bleach

– daily if working with biohazards
– monthly if not working with biohazards

Wash

•

As needed using distilled water

•

Four times after system calibration

•

Twice after sanitize

Advertising