Micromod Micro-DCI: 53IT5100B Micro-DCI 4-Channel Indicator Totalizer - Manual (Page 31)

53IT5100B Indicator/Totalizer
INSTRUCTION MANUAL
27
3.3.2 Displaying a Datapoint
The following procedure illustrates how to display the contents of datapoint C175, which is ANI2 Alarm Limit
1. Figure 3-9 contains supporting illustrations for the display procedure described in Table 3-2. (Notice in
these illustrations that ANI-2 Alarm Limit 1 is set at 80.)
Table 3-2. Procedure to Display a Datapoint
Step Press
Once
Shift
Result
Press to
Locate
Target
Char.
Result
1  Puts instrument in engineering mode.
2 If DISPLAY does not appear, press F2.
3 F3 Displays entry line: POINT
4

C Puts C on entry line: POINT .C.
5

.CΔ  1
Shifts C and puts 1 on entry line:
POINT .C1.
6

.C1Δ  7
Shifts C1 and puts 7 on entry line:
POINT .C17.
7

.C17Δ  5
Shifts C17 and puts 5 on entry line:
POINT .C175.
8 F3
Enters address to display datapoint contents.
The address with the contents are displayed as
follows: C175 80.0000
9  Returns instrument to operator mode.

NOTE: Δ indicates Space
Figure 3-9. Displaying a Datapoint