Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Instruction Manual User Manual

Page 93

Advertising
background image

•

The screen should now appear as shown on the right.

•

If the required key-code is "222222", follow the follow-
ing procedure.

•

Press the key until the digit "2" appears on the
entry line.

•

Press the key to shift the first entry one position to
the left.

•

Press the key until the next "2" appears on the
entry line.

•

Press the key to shift this entry one position to the
left.

•

Repeat this procedure until all of the key-code charac-
ters have been entered on the entry line.

•

The display should now look as shown on the right.

•

When all of the characters have been entered, press
F3.

•

Pressing the F3 key enters the password key and en-
ables display and entry of either the MODULE o r
DATAPOINT modes which will be discussed later.

•

The engineer mode configuration function is now ready
for use.

•

The screen should now appear as shown in one of the
following screens (the rightmost screen represents the
low-resolution display).

53MC5000 Process Control Station

3-10

Advertising