Diamond Products DZ-S2 - Manual (Page 19)

DZ-S2 Set-up
DZ-S2_e_0210.fm Page 19
 5HSODFLQJ VDZ PRWRU
'LVDVVHPEOH VDZ PRWRU
z Switch off drive unit
z Reduce pressure (see drive unit operating
instructions)
z Uncouple hoses from saw motor
- Rotate locking ring
- Hold hose straight
- Slide back coupling sleeve
- Pull off hose
z Loosen Allen screws.
z Rotate saw motor and remove.
0RXQW VDZ PRWRU VL]H
z Position saw motor with toothed profile
coupling on the drive shaft and rotate
z Tighten M8 Allen screws
&RQQHFW KRVHV
z Push the hose coupling onto its counterpart
until you hear it “click”
z Rotate the locking ring of the coupling
Never connect or disconnect
hoses when the drive unit is
running.
Keep hose couplings clean and never allow
them to drop.
Do not uncouple hoses at the drive unit side,
so that pressure can be reduced via the
drive unit.
Gr. 2
Ensure that the hydraulic hoses
are properly coupled. Always
rotate the locking ring following
coupling.