7 anchoring saw blade for flush cutting, Qfkrulqj vdz eodgh iru ioxvk, Fxwwlqj – Diamond Products DZ-S2 User Manual
Page 25: Qfkrulqj vdz eodgh iru ioxvk fxwwlqj, Dz-s2 anchoring saw blade for flush cutting
DZ-S2
Anchoring saw blade for flush cutting
DZ-S2_e_0210.fm
Page 25
$QFKRULQJ VDZ EODGH IRU IOXVK FXWWLQJ
z
Always fasten the saw blade with all screws
supplied and use only screws of the correct
grade.
z
Always switch off the drive unit and relieve
the pressure in the hoses before handling
the saw blade.
$VVHPEO\
z
Secure flush cutting flange (2) with 6 Allen
screws (4) onto blade holder (5).
z
Place saw blade (1) with a 60 dia. hole on
the flush cutting flange (2)
z
Secure saw blade with countersunk head
screws (3) onto blade flange (2).
If the saw blade is not properly secured, it may
come loose and cause serious injury. It is
therefore essential to closely follow the
instructions below.
If the drive unit is running or if the hoses are
under pressure, a stationary saw blade can still
suddenly rotate and seriously injure someone. It
is therefore essential to closely follow the
instructions below.
Use the following screws only:
Allen screws M8x16, 12.9 DIN 912,
order no. 971732
Use the following screws only:
Countersunk head screw M8x16, 10.9 DIN 7991,
order no. 971825