Diamond Products DZ-S2 - Manual (Page 24)

Anchoring saw blade for normal cutting DZ-S2
Page 24 DZ-S2_e_0210.fm
 $QFKRULQJ VDZ EODGH IRU QRUPDO FXWWLQJ
z Always switch off the drive unit and relieve
the pressure in the hoses before handling
the saw blade.
$VVHPEO\
z Place saw blade (1) with a 60 dia. hole on
the blade flange (5)
z Saw blade alignment:
Countersinkings against blade cover (2)
z Screw down the blade cover (2) with 1
hexagon head cap screw (6) onto the blade
flange (5).
If the saw blade is not properly secured, it may
come loose and cause serious injury. It is
therefore essential to closely follow the
instructions below.
If the drive unit is running or if the hoses are
under pressure, a stationary saw blade can still
suddenly rotate and seriously injure someone. It
is therefore essential to closely follow the
instructions below.
Use the following screws only:
Hexagon head cap screw M16x30,
order no. 971937