9 sawing, 1 before sawing, 2 the first cut (precut) – Diamond Products DZ-S2 User Manual
Page 27: 6dzlqj, Before sawing, The first cut (precut)
DZ-S2
Sawing
DZ-S2_e_0210.fm
Page 27
6DZLQJ
%HIRUH VDZLQJ
Follow the instructions below:
z
Check direction of travel and swivelling
motion
z
Teeth of rails must be clean
z
Cut guides on rail supports must be folded
in
z
Cover sharp-edged objects
z
Check that all dowel screws on the rail
supports have been tightened
z
Check that all rail supports are firmly
secured to the rail
z
Rail limit stops must be mounted
z
Check if water is emerging at the point of
rotation of the saw blade
z
Test run:
Run the wall saw head along the entire
length of the rail and check that the hoses
do not catch at any point
7KH ILUVW FXW SUHFXW
3URFHGXUH
z
Move wall saw head to starting position
z
Sawing
Never saw without the blade
guard.
Note:
- if possible do not cut through any reinforcements
- swivel arm pulled
- cutting depth 5-10 cm
- working pressure 100-120 bar
5-1
0
cm