Diamond Products DZ-S2 - Manual (Page 20)

Set-up DZ-S2
Page 20 DZ-S2_e_0210.fm
 0RXQWLQJ 9UDLOV RQ FRQFUHWH
A Normal cut
B Flush cut
1. V-rail
2. Clamp
3. Adjusting nut
4. Adjusting screw
5. Dowel screw
6. Clamping block
7. Grease nipple
8. Adjusting foot
9. V-rail support
10. Cut guide
Use the following:
- for each dowel screw (5) the clamping blocks (6)
- steel plug: dia. 15 mm / M12
- screws (5): length = 130 mm
-
WZR rail supports for the first V-rail, one rail support for
each additional V-rail
Please note the following:
Incorrect mounting of the rails
can endanger people during
sawing.