Nitek MNG6448 - Manual (Page 23)

23
To optimize the communication between your LAN, link test is designed to test the parameters that indicates com-
munication quality.
RF Cable Loss: Input the value of local and remote RF Cable loss.
Local Antenna Gain: Input a value for the Local Antenna Gain.
Remote Antenna Gain: Input the value for the Remote Antenna Gain.
Test Interval: Input a value for the Send Packet Interval.
Test Packet Size: Input the value of Send Packet Size.
Test Time: Input a value for the Test Time.
Notice: For accurate test results, you should make sure that the Link Test settings are correct.
The signal strengthen (dBm) is a negative value, the lower the absolute value is, the better the signal strength-
ens. For a greater throughput in the wireless network, you should adjust the signal strengthen for a better signal.
The signal strengthens (Percent) is just a reference value. It relies on not only the real signal strengthen but also
the academic signal strengthen which relies on the Link Test settings. So you should take the signal strengthens
(dBm) as a reference when adjusting antennas.