Nova-Tech PGW Series - Manual (Page 13)

Page 13 of 44
9.0 OPERATIONS
9.1 INITIALISATION
When the balance is first switched on, it
will display the balance serial number (if
set), software revision, model capacity
and then all segments on the display will
be shown. Overall the time taken is
usually 5 -10 seconds.
If a passcode has been set, the display will show “
PASSCODE” and the main
display will show a zero. In this case you must enter the passcode to
continue using the numeric entry method (see section 7.1). A different
passcode may be set for a Supervisor to weigh or to have access to the
selected User menus. If the passcode has not been set the balance will
continue as below.
The display will show zero reading along
with the zero symbol “
О0Н” and the
weighing unit last used. If automatic
time calibration is enabled the balance
will calibrate after power up and again
after the pre-set time interval.
9.2 PASSCODES
If a passcode has been set to limit access to the weighing functions of the
balance the display will show “PASSCODES” with the main digit set to zero.
The display will change to show 7 digits set to zero with the rightmost digit
flashing. Use the numeric entry method (see section 7.1) to enter the code.
Make sure to enter the correct passcode to continue. See the Section 13.6
for details.
© Adam Equipment Company 2007