Nova-Tech PGW Series - Manual (Page 27)

Page 27 of 44
Tare weight Tare: xxx.xxx g
Unit weight Unit wt: xxx.xxx g
Count Count: xxxx pcs
Reference weight Ref. wt: xxx.xxx g
Percent Percent: xx.xxx %
Checkweigh lower limit Low: xxx.xxx g
Checkweigh upper limit High: xxx.xxx g
A blank line printed <CR><LF> only.
Any of these can be printed on any of the 15 lines available. Not all items
need to be used and any one can be used more than once (see section 13.3).
The data for each form will be preceded by a start-of-header <SOH>
character (01) and terminated with an end-of-transmission <EOT> character
(04). These characters will be ignored by a serial printer but will allow a
computer program which reads the data to distinguish between this block
report format and the single-line output format described above.
STANDARD FORMAT
The balance will print the following data as the standard form. The standard
form cannot be changed. The format of the custom forms #1 and #2 will be
the same as the standard form until modified by the user.
Line 1 Date
Line 2 Time
Line 3 Blank line
Line 4 ID number
Line 5 Blank line
Line 6 Result
Line 7 Blank line
Line 8 Blank line
This will result in a printout that looks like:
Date: 23/09/04
Time: 15:45
ID No: 123456
Net: 123.456 g
*NOTE: The format of the results line will change depending on the mode in
which the balance is operating, e.g.
Normal weighing, Check weighing, Animal weighing: “123.456 g”
Parts counting: “1234 pcs”
Percent weighing: “12.345 %”
© Adam Equipment Company 2007