Nova-Tech PW Series - Manual (Page 11)

Page 11 of 48
© Adam Equipment Company 2007
7.0 KEYPAD
The keypad has the following keys to operate the balance.
Keys Primary function Secondary function
To turn the balance to ON or
Standby -
[ 0/T] or
[Esc]
A combined zero and tare
function To escape from setup
functions and modes
[Unit] / or
[Down] Selects weighing units by
cycling through a set of
enabled units To decrement or change a
displayed value or scroll
through options backwards
[Mode] / or
[Advance]
Enters the Modes To advance a flashing digit
by one position to the right.
To go back by one step
during setup functions
[Print] /  or
[Back] Instructs the balance to print
data To advance a flashing digit
by one position to the left
[Cal] / or
[Up] Starts the calibration function
To increase or change a
displayed value or scroll
through options forward
[Setup]/
or
[Enter]
Enters the Setup parameters
(Supervisor Menus) Enters a function or saves
a value while manually
entering unit weight or
check weighing limits
7.1 NUMERIC ENTRY METHOD
To set a value when required, use the keys as given below-
- [Up] and [Down] keys to increase or decrease the flashing digit,
- [Advance] and [Back] keys to advance or move back the digit and
- [Enter] key to accept the value