Nova-Tech PW Series - Manual (Page 21)

Page 21 of 48
© Adam Equipment Company 2007
9.4.4.1 Animal Weighing Setup Parameters
• Press [Mode] and then [Up] or [Down] to select Animal Weighing.
When “ANIMAL” is displayed press [Enter] to enter the function
• Press the [Up] or [Down] key to select “rUN” or “SEtUP”
• Press [Enter] to select “SEtUP” to set up the balance for animal
weighing
• Use the [Up] or [Down] key to scroll through the options for setting up
the mode. The display will show “MODE AUTO” or “MODE MANUAL”.
• Select “MANUAL” or “AUTO”
If “AUTO” is selected-
Threshold (During AUTO mode only)
• The display will next show “THRESHOLD XX g” where XX is the
minimum weight of the item required by the balance to start the process
for animal weighing. The value will be shown in the last selected unit.
• The XX can be changed from 1 to 99 using the numeric entry method
(see section 7.1)
• To confirm the desired value, press [Enter]
Test time
• After [Enter] is pressed to select “MODE MANUAL” or “MODE AUTO”,
it will display “TEST TIME XX”, where XX is the number of seconds
over which the balance will average to compute the final weight as set
during last operation
• The XX can be changed from 1-200 using the numeric entry method
(see section 7.1)
• To confirm the desired value, press [Enter]