Poweramp VS SERIES HYDRAULIC - Manual (Page 22)

20 4111-0008 — Sept 2012
End Loading/Unloading — Platform at Cross-Traffic Position.
OPERATION
NOTE: If end unloading is required, see End
Loading/Unloading Instructions on page 21.
1. Check to make sure truck/trailer is positioned
squarely against dock bumpers.
2. Instruct driver to remain at the dock until the
loading or unloading process has been completed.
3. Chock the truck/trailer wheels or use the truck
restraint if available.
Ramp Loading/Unloading Instructions
4. Lower the platform lip onto truck/trailer as follows:
a. Lower platform by pushing and holding LOWER
button.
b. Make sure that the lip is fully extended and
supported on the truck/trailer along the entire
width of the platform with at least 4 in. (102
mm) of lip contacting the truck bed.
7. When loading or unloading is finished, raise the
platform by pushing and holding RAISE button.
When fully raised the leveler will shut off and the
Blue stored light will come on.
8. Remove chocks from truck/trailer wheels or
release the truck restraint if used.
9. Indicate to driver that truck may leave the
dock.
A—LOWER Button
B—RAISE Button C—STORED Button
5. Proceed with loading or unloading the truck/trailer.
6. If end loading is necessary, see End Loading/
Unloading Instructions on page 21.
Operating Instructions—Continued
A
C
B