Poweramp VS SERIES HYDRAULIC - Manual (Page 7)

5 4111-0008 — Sept 2012
SAFETY
Safety Decal’s
CRUSH HAZARD
DO NOT WORK UNDER DOCK LEVELER unless all
maintenance props have been properly positioned.
Side maintenance props must be positioned as shown
in figure “A” below. Prop locking pin must be positioned
as shown in figure “B” below. Refer to owner’s/user’s
manual for proper procedure. Failure to do so will
result in death or serious injury.
FIG.“A”
Storage
Position
Maintenance Position
4.00"
6.
25"
Control Box Size:
Decal Size: 4 x 6.25
File Name: 1751.0230 REV C
DANGER !
FIG.“B”
Control Box Size:
Decal Size: 4 x 2
File Name: 1751-0138 Rev A
DANGER !
CRUSH HAZARD
DO NOT REMOVE hydraulic cylinder until leveler is
safely supported by maintenance prop. Refer to
owner’s/user’s manual for proper maintenance
procedure. Failure to comply will result in death or
serious injury.
Control Box Size:
Decal Size: 4 x 6
File Name: 1751-0130 Rev A
DANGER !
CRUSH HAZARD
DO NOT ENTER PIT unless dock
leveler is safely supported by
maintenance prop. Place barriers on
drive way and dock floor to indicate
service work being performed. Refer to
owner’s/user’s manual for proper
maintenance procedures. Failure to
comply will result in death or serious
injury.
DANGER !
If for any reason, the platform is raised by
means other than the hydraulic system, i.e.
Fork truck or crane, a hazardous condition may
exist, because the main hoist cylinder will have
air on the load bearing end. The cylinder will
not support the platform which can fall rapidly,
potentially causing injuries to anyone under the
platform. Be sure the leveler is restrained per
instructions in the owner’s/user’s manual. When
repairs/service is complete unit must be
operated in the “raised” direction only until
visible movement of platform indicates cylinder
is full. If alternate lifting means are still
available, use to return platform to original
lowered position and then raise unit
hydraulically.
Safety Decal on Rear Platform
Safety Decal on Rear Platform
Safety Decal on Platform Cylinder
Safety Decal on Leveler Frame