PROLiNK PPS2104N User Manual - Manual (Page 17)

EN 14
f) After you finish using the USB device, click the USB device in the ShareHub Device Servers Control Center
and then click the “Disconnect” button to disconnect the USB device. Other PCs cannot “Connect” the USB
device until you “Disconnect” that USB device. That is to say, only one PC is allowed to connect the USB
device at the same time.
4.6. Auto-Connect Printer
The method described in section 4.5 is so-called manual-connect, which means users must manually connect
the USB device before using that device, and must manually disconnect the USB device after using the device;
otherwise nobody else can connect this device. However, for printers and scanners (and MFPs), the ShareHub
Device Servers supports auto-connect so users don’t need to manually connect/disconnect. This and the next
sections show you how to do this.
After the driver is installed as described in section 4.4, you can see a newly created printer in the Control
Panel’s “Printers and Faxes”. Follow the steps below to do a NetUSB auto-connect printing.
a) In the ShareHub Device Servers Control Center, click the ShareHub Device Servers that has the desired
printer (or MFP) attached.
b) Click the desired printer (or MFP).
c) Click the “Auto Connect Printer” button and choose “Set Auto-Connect Printer”.