PROLiNK PPS2104N User Manual - Manual (Page 25)

EN 22
h) If you clear Enable SMB/CIFS Print/File Server Authentication in Supported Protocols, you login to the SMB
server without requiring authentication; otherwise you have to enter user name and password to login to
the Server. You can add user name and password in User Account box by the ShareHub Device Servers
Control Center or the Server’s Web page.
Note:
If you use SMB on Windows 98 SE/ME, you must login to your Windows 98 SE/ME using the same user name
as in the Server’s User Account.
i) The shared folders will be listed as USB1_DyPz, and USB2_DyPz where Dy represents the y-th disk and Pz
represents the z-th partition with respect to USB1 port and USB2 port.
j) Perform Open, Paste, Remove or Copy the files to the shared folders.
5.5. Using Shared Storage by FTP Methods for Windows
5.5.1. Use Microsoft IE to the shared USB Mass Storages
a) Open Microsoft IE
b) In Web Address List, enter command: “ftp://Server’s Server Name“ or “ftp://Server’s IP address”. If
you have changed the default FTP port : 21 to the new value, you have to add the new port
number in the tail of command as “ftp://Server’s Server Name: ftp port” or “ftp://Server’s IP
address: ftp port”.
c) If you set Enable Server Authentication in FTP server protocol settings you have to enter user
name and password to login to the Server; if you set Allow Anonymous Login, you can use the
user name “anonymous” to login with Read-only permission. If you clear Server authentication,
you do not need username or password to login to the Server. You can add user name and
password in User Account box by the ShareHub Device Servers Control Center or the Server’s Web
pages.
d) The shared folders will be listed in IE.
e) Perform Paste, Remove or Copy the files to the shared folders.
5.5.2. Use Microsoft Dos’s FTP client
a) Enter DOS command “ftp”.
b) Enter “open server’s Server Name” or “open server’s IP address”. If you have changed the default
FTP port : 21 to the new value, you have to add the new port number in the tail of command as
“open server’s Server Name ftp port” or “open server’s IP address ftp port” .
c) If you set Enable Server Authentication in FTP server protocol settings you have to enter user
name and password to login to the Server; if you set Allow Anonymous Login, you can use the
user name “anonymous” to login with Read-only permission. If you clear Server authentication,
you do not need username or password to login to the Server. You can add user name and
password in User Account box the ShareHub Device Servers Control Center or the Server’s Web
pages.
d) Perform FTP commands to use this FTP server.