PROLiNK PPS2104N User Manual - Manual (Page 31)

EN 28
9. Upgrade Firmware
This chapter describes how to upgrade firmware. Please follow one of the following Procedures:
Procedure A: Using the ShareHub Device Servers Control Center
a) Open ShareHub Device Servers Control Center. It will automatically search the existing Servers and display
their statuses.
b) Select the Server that you want to upgrade the firmware. Double click the selected Server to get the
serve’s main web page.
c) Click CONFIG icon.
d) Login the Server with Administrator (default: admin) and Password (default: admin).
e) Click Maintenance.
f) Click Upgrade Firmware.
g) Click Browse button to choose the file of new firmware.
h) Click Upload button to start firmware upgrade.
i) Wait for 20 seconds for system reboot.
Procedure B: Using the Init Button and the TFTP Client
a) Plug in the power adaptor while pressing the Init button until LED indicators of USB1 and USB2 blink. (For
PPS2101/PPS2101N, only USB1 LED will blink.) Please note that after that, the Server will operate using the
factory default values after restarting, i.e., your Server’s configuration will recover to Factory Default values.
b) Run the TFTP client Tool: Image Burner, from Windows Start menu.
c) Click Open Image to open your new firmware. Please note that you must configure your PC’s TCP/IP such
that PC and the Server belong to the same LAN, i.e. PC’s IP is 192.168.1.xxx and subnet mask is
255.255.255.0.
d) Click Upload Image.
e) Wait for Image Uploading to finish and then click Close.
f) Plug-off the power adapter and then plug-in the power adapter to restart the Server.