Actiontec electronic Actiontec Wireless DSL Gateway GT701WG - Manual (Page 9)

6
Actiontec 54 Mbps Wireless DSL Gateway User Manual
Phone Port
The Phone port is used to connect the Gateway to a
telephone .
USB Port
The
USB port is used to connect a computer to the Gateway via USB cable.
Ethernet Port
The Ethernet port is used to connect a computer to the Gateway via Ethernet
cable. The Ethernet port is a
10/100 Mbps auto-sensing port, and either a
straight-through or crossover Ethernet cable can be used when connecting to
the port.
Reset Switch
Depressing the Reset switch for one or two seconds will power cycle the Gateway
(similar to unplugging and then plugging in the Gateway’s Power cord). To
restore the Gateway’s factory default settings, depress and hold the Reset switch
for approximately
10 seconds. The reset process will start about 10 seconds after
releasing the switch.
Power Port
The Power port is used to connect the Power cord to the Gateway.
N
Warning: Do not unplug the Power cord from the Gateway’s
Power port during the reset process. Doing so may result in per-
manent damage to the Gateway.