Fulton Reliance (RLN) High Efficiency Cooper Fin Boiler - Manual (Page 54)

© The Fulton Companies 2012
WARRANTY & PARTS
RLN-IOM-2012-1205
SECTION 5
5-2
Standard Warranty for Fulton Reliance Boilers
Warranty Valid for Models RLN
Ten (10) Year Thermal Shock Warranty
Fulton Heating Solutions guarantees the Reliance heat exchanger against thermal shock for a period of ten (10) years when the boiler is
installed as a closed loop hot water boiler and is operated per the Installation and Operation Manual. This guarantee will cover damage due
to thermal shock, such as leaks in the heat exchanger. This guarantee does not cover damage due to corrosion, scaling, sooting or improper
installation or operation. The fl ow rate through the boiler must be consistent with the requirements in the equipment manual.
The guarantee is limited solely to the repair or replacement of the components listed above. An inspection must be performed by Fulton or
their Representative to determine the cause of the damage. The warranty does not cover labor or freight.
Five (5) Year (60 Month) Material and Workmanship Warranty
The pressure vessel is covered against defective material or workmanship for a period of fi ve (5) years from the date of shipment from the
factory. Fulton will repair or replace F.O.B. factory any part of the equipment, as defi ned above, provided this equipment has been installed,
operated and maintained by the buyer in accordance with approved practices and recommendations made by Fulton. The commissioning
agency must also successfully complete and return the equipment Installation and Operation Checklists to Fulton’s Quality Assurance
department. This warranty covers any failure caused defective material or workmanship; however, waterside corrosion or scaling is not
covered. Therefore, it is imperative that the boiler be installed in a closed loop as outlined in the Installation and Operation Manual.
Parts Warranty
Fulton will repair or replace F.O.B. factory any part of the equipment of our manufacture that is found to be defective in workmanship or
material within one (1) year of shipment from the factory provided this equipment has been installed, operated and maintained by the
buyer in accordance with approved practices and recommendations made by both Fulton and the component manufacturers and the
commissioning agency has successfully completed and returned the equipment Installation and Operation Checklists to Fulton’s Quality
Assurance department.
General
Fulton shall be notifi ed in writing as soon as any defect becomes apparent. This warranty does not include freight, handling or labor charges
of any kind.
These warranties are contingent upon the proper sizing, installation, operation and maintenance of the boiler and peripheral components
and equipment. Warranties valid only if installed, operated, and maintained as outlined in the Fulton Installation and Operation Manual.
No Sales Manager or other representative of Fulton other than the Quality Manager or an offi cer of the company has warranty authority.
Fulton will not pay any charges unless they were pre-approved, in writing, by the Fulton Quality Manager.
This warranty is exclusive and in lieu of all other warranties, expressed or implied, including but not limited to the implied warranties of
merchantability and fi tness for a particular purpose. Fulton shall in no event be liable for any consequential or incidental damages arising in
any way, including but not limited to any loss of profi ts or business, even if the Fulton Companies has been advised of the possibility of such
damages. Fulton’s liability shall never exceed the amount paid for the original equipment found to be defective.
Excessive cycling will reduce the life of ANY boiler. Verify that your system is properly designed and check cycling rate according to
maintenance procedures listed in this manual.
To activate the warranty for this product, the appropriate commissioning sheets must be completed and returned to the Fulton Quality
Assurance department for review and approval.
9/25/2009