Teledyne 9110TH - Nitrogen Oxides Analyzer - Manual (Page 144)

Model 9110TH NOx Analyzer Operating Instructions
Teledyne Analytical Instruments 124
The available gas concentration DAS parameters for output via the 9110TH/M analog
output channels are:
Table 4-23: Analog Output DAS Parameters Related to Gas Concentration Data
REPORTING
RANGE
PARAMETER
NAME 1
DESCRIPTION
NO
x
Range 1
(LOW)
NXCNC1 Concentration
NXSLP1 Slope
NXOFS1 Offset
NXZSC1 Concentration during calibration, prior to computing new slope and offset
NO
x
RANGE 2
(HIGH)
NXCNC2 Concentration
NXSLP2 Slope
NXOFS2 Offset
NXZSC2 Concentration during calibration, prior to computing new slope and offset
NO Range 1
(LOW)
NOCNC1 Concentration
NOSLP1 Slope
NOOFS1 Offset
NOZSC1 Concentration during calibration, prior to computing new slope and offset
NO RANGE 2
(HIGH)
NOCNC2 Concentration
NOSLP2 Slope
NOOFS2 Offset
NOZSC2 Concentration during calibration, prior to computing new slope and offset
NO
2
Range 1 2
(LOW)
N2CNC1 Concentration - Computed with data from NO
x
Range 1 and NO Range 1
N2ZSC1 Concentration during calibration, prior to computing new slope and offset
NO
2
RANGE 2 2
(HIGH)
N2CNC2 Concentration - Computed with data from NO
x
Range 2 and NO Range 2
N2ZSC2 Concentration during calibration, prior to computing new slope and offset
O
2
Range 3
O2CONC 3 Concentration
O2OFST 3 Slope
O2SLPE 3 Offset
O2ZSCN 3 Concentration during calibration, prior to computing new slope and offset
1 Parameters are not listed in the order they appear on the DAS list (see Table A-6 or Appendix A.5 for the proper order of the full list of
parameters)
2 Since NO
2
values are computed rather than measured directly, no separate slope or offset exist.
3 Only available on instruments with O
2
sensor options installed.