Fairbanks FB3000 II Operators Manual - Manual (Page 37)

Section 4: Input/Output (I/O)
02/10 37 51220 Rev. 1
4.4.2. IP Network Output Setup Instructions, Continued
15. Use the Mode drop down list to
select the Network mode.
16. Select the IP Setup tab to
configure the network
parameters. Pointing to each
edit box will display a brief help
message, to assist in the setup
17. Program the IP Port Settings.
by setting the Local Port and
the Remote Port to the same
number as appropriate for the
users network.
Example: port = 2000.
• Set the Remote Host to
one of the following
ƒ The IP address of the remote computer which will receive the weight data,
ƒ The network computer name of the remote computer which will receive the
weight data as in the example shown above.
18. Firewall Settings – Leave the
defaults as shown
19. The customer will need to
provide a receiving application
on a network computer which will
open a connection through a
TCP/IP socket with
• The IP address must be set
to the address of the FB3000
II and the Port set to the
FB3000 II Local Port setting.
Example: 2000.
• When the IP is configured
correctly, it will display
Listening .
20. The data steam will be a
continuous stream in the format set in step 6 above.