Fairbanks FB3000 II Operators Manual - Manual (Page 65)

02/10 65 51220 Rev. 1
Appendix VIII: Remote Functions
Hardware Connections
REMOTE FUNCTIONS CN14
Remote Zero Switch 3 11 or 12
Remote Print Switch 9 11 or 12
*Dry contacts only.
**Must have I/O accessory installed.
Remote Software Commands using Serial Port/ Mapped Memory/ Multicast
FUNCTION SOFTWARE COMMAND
Zero Active Scale Z
Zero ALL Scales z
Zero a Specific Scale Z#
where # is the Scale number.
Zero Scales 1-4 ZA
Zero Scales 5-8 ZB
Set Tare on Active Scale Txxxxx
where xxxxx is the Tare weight value.
Set Tare on a Specific Scale T#, xxxxx
where # is the Scale number and
xxxxx is the Tare weight value.
AutoTare on Active Scale A
Change Units on Active Scale U
Change Units on ALL Scales u
Change Units on Specific Scale U#
where # is the Scale number.
Print Active Scale P
Change to Multi-Screen m
Change to GTN Screen g
Select Active Scale S#
where # is the Scale number.