Fairbanks VSX SERIES TRUCK SCALE - Manual (Page 17)

Section 2: Installation
04/12 17 51173 Rev. 8
Assemble the Left Hand Base Module, continued
2. Install the cross members.
a. There are two (2) different types of cross members. See Table 2-1 to
identify them.
b. Place the appropriate cross members at the appropriate location. The
channel should be toward the bottom. The cross member should sit on top
of the bar on the girder flange.
c. Loosely bolt each end of the cross member to the main girder including
one spring lock washer per bolt. Do not fully tighten.
d. The cross member bolt head should be at the exterior side of the main
girder.
Cross Section View Installation Locations
One at each end of every
module.
At each through web bolt
hole location.
Table 2-1