Gentec-EO MACH 6 User Manual
Page 3
Mach 6 User’s Manual Revision 2.1
3
SAFETY INFORMATION
Do not use the MACH 6 if the device or the detector looks damaged, or if you suspect
that the MACH 6 is not operating properly.
Appropriate installation must be done for water-cooled and fan-cooled detectors. Refer
to the specific instructions for more information. Wait a few minutes before handling the
detectors after power is applied. Surfaces of the detectors get very hot and there is a risk
of injury if they are not allowed to cool down.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy. If not installed and used in accordance with the instructions,
it may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, try to correct the
interference by taking one or more of the following steps:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment to an outlet that is on a different circuit than the
receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Caution:
Changes or modifications not expressly approved in writing by Gentec-EO Inc.
may void the user’s authority to operate this equipment.
SYMBOLS
The following international symbols are used in this manual:
Refer to the manual for specific Warning or Caution information to
avoid any damage to the product.
DC, Direct Current