Gentec-EO MACH 6 - Manual (Page 7)

Mach 6 User’s Manual Revision 2.1 7
6. Leave the CD in your PC as the USB drivers are located on the disk and are needed
for step 2.
Step 2, Installing the USB Drivers
1. Connect the Mach 6 to your PC with the supplied USB cable.
2. Connect the power supply and turn on the Mach 6.
3. The Found New Hardware Wizard will run. If the Windows Update prompt
appears, select No, not this time and press Next.
4. When the Install from CD appears, select Install Software Automatically and
press Next.
5. When the Completing prompt appears, select finish.