Gentec-EO PC-MAESTRO (Old Software for MAESTRO) - Manual (Page 17)

PC- MAESTRO User’s Manual Revision 1.0 16
4 GETTING STARTED
4.1 Connect your MAESTRO to the PC-MAESTRO.
1. Connect your MAESTRO to the PC using a USB cable. Use the correct port as identified in the
picture below.
2. Install the PC-MAESTRO on the PC.
3. Power up the MAESTRO
4. Start the PC-MAESTRO
5. Click on the
“Connection” button in the Main Controls ribbon. The software will scan each port on
your computer and connect the PC to the first port connected to a MAESTRO.
Fig. 3-10 Correct USB port to plug a MAESTRO to a PC
4.2 To disconnect your MAESTRO
Click on the “Disconnect” button in the main controls ribbon.
4.3 To change the measurement settings of your detector head
To change the behavior of the detector head plugged into a MAESTRO, go to the “Set Measure” tab
panel.